Skip to content
Welcome to Osmo Africa - Call us on 087 238 0762 for any technical advice
Welcome to Osmo Africa - Call us on 087 238 0762 for any technical advice

OSMO PolyX-Oil, 3088, Anti-Slip, Clear Semi-Matt (R9), 750ml

by Osmo
R 999.90


Osmo PolyX-Oils are developed from natural oils and waxes to provide the most hardwearing and durable protection for wooden flooring and furniture.


Anti-Slip PolyX-Oil is resistant to water and dirt, is very durable. Special additives give a structure to the dry finish and help to achieve a slip resistance up to R9 classification. The hardwax-oil finish retains the natural character of the wood, is microporous and does not crack, flake, peel or blister.




SURFACE PREPARATION

Osmo UV-Protection-Oil Extra is ready to use. Do not thin. Stir well before use.
If possible, please apply the first coat to all sides before installation.



Fresh wood, containing natural wood extractives and especially hard wood needs to weather off (for approximately 6 weeks) after installation. Thereby the wood becomes absorbent and the wood finish adheres optimally.



A coloured base coat is recommended, e.g. Osmo One Coat Only, Natural Oil Woodstain or Country Colour.



For renovations, clean old microporous wood finishes thoroughly. Degrey any already greyed wood with Osmo Wood Reviver Power-Gel before applying Osmo.


Clean old microporous stains thoroughly.
Old paints and lacquers must be completely removed.



As a general rule, wear a dust mask during sanding works. Do not sand smooth surfaces finer than P120.



The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.



If additional protection against blue stain, rot and insects is desired, pre-treat the wood if possible on all sides with Osmo WR Base Coat.


METHOD OF APPLICATION


With Osmo Flat Brush or Microfibre Roller, apply thinly along the wood grain and spread well.



Allow to dry for approx. 12 hours under good ventilation. Then apply the second coat.



When recoating colour treated surfaces, or for renovation works, one coat applied to the clean and dry surface is usually sufficient.


VIDEO